Open Access
Issue
BIO Web Conf.
Volume 34, 2021
International Scientific Conference “Biologization of the Intensification Processes in Horticulture and Viticulture” (BIOLOGIZATION 2021)
Article Number 06006
Number of page(s) 6
Section Biotechnologies of Storage and Processing of Agricultural Products, Quality Management and Food Safety
DOI https://doi.org/10.1051/bioconf/20213406006
Published online 10 September 2021

© The Authors, published by EDP Sciences, 2021

Licence Creative CommonsThis is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.

1 Introduction

Food quality control is an integral part of the overall food safety system [16]. The methods and approaches used in the study to disclose the mechanisms of sorption and removal of antibiotics of microbial origin from wines to increase consumer safety and control the quality of wine products are comparable to the studies of foreign scientists [16].

Such studies include the work of Chinese scientists to improve the methods of analysis of antibiotic and to establish the efficiency of removing natamycin from wines by sorbents of various nature [2].

The identification of the mechanisms of sorption of antibiotics of microbial origin by sorbents of different nature, exhibiting different mechanisms of action, was carried out taking into account modern approaches to the physical chemistry of dispersed systems and colloidal phenomena in these systems, considering the current state and development trends in the field of sedimentation analysis.

The aim of this study was to evaluate and compare the interaction of bacteriocin nisin and fungicide of the polyene macrolide group of natamycin (pimaricin) with sorbents of various types.

Algorithms for the identification of food additives (preservatives and antibiotics of a microbial nature) in wine products are relevant for the production sector when using imported raw materials, as well as for ensuring consumer safety of alcoholic beverages [5,6].

2 Materials and methods

To establish the effective adsorption capacity of sorbents to remove antibiotics of microbial origin from wine, a model system was used. It was a mixture of dry table white wine of the Chardonnay variety and antibiotics nisin (E234) and natamycin (E235) at a mass concentration of 25 and 50 mg/dm3, respectively. The amount of applied antibiotics was determined based on the analysis of literature data.

Colloidal silicon dioxide (highly dispersed silica «Polysorb» with a particle size of up to 0.09 mm), activated carbon (vegetable coal with a specific surface area of about 1400 m2/g) and bentonite (in the form of a suspension of bentonite clays containing no colloidal fraction no less than 80%) were used as sorbents. The studied dosages of sorbents were 0.5; 1; 1.5 and 2.0 g/dm3.

Highly efficient capillary electrophoresis was used as the main analytical method for determining the residual amounts of antibiotics of microbial origin: (The authors used methods for the determination of natamycin (patent 2018102766/15 Method for the determination of natamycin by capillary electrophoresis) and nisin (a technique developed by scientists of the FSBSI NCFSCHVW: STO 00668034-086-2017 “Alcoholic and nonalcoholic beverages. Determination of nisin by capillary electrophoresis).

The sorption efficiency was assessed by the difference between the concentrations of antibiotics before and after treatment with sorbents at different dosages.

All determinations and tests were carried out in duplicate.

3 Results and discussion

It is known that activated vegetable carbon is an inert (odorless and tasteless) active carbon adsorbent for eliminating a number of defects in wine. Typically used to remove off-flavors in wort and wine, it is particularly effective for treating against moldy flavors, herbaceous flavors, and for decontaminating the mycotoxin ochratoxin A [7,8,9].

The high efficiency of the sorption of antibiotics by activated carbon was established, at a dosage of 1 g/dm3 - 80 % for nisin and 78% for natamycin. In our opinion, the high degree of removal of nisin and natamycin is associated with the high sorption capacity of activated carbon and its developed effective specific surface, capable of actively interacting with high molecular weight components of wine, including nisin and natamycin. With an increase in the dosage of the sorbent to 2 g / dm3, the sorption efficiency remained at the level of 80%, however, a strong discoloration was observed, which can negatively affect the color intensity of wines (Fig. 1).

Silicon dioxide (“Polysorb”) is an inorganic non-selective polyfunctional sorbent that has pronounced sorption properties and binds toxic substances of various natures, including pathogenic bacteria and bacterial toxins, antigens, food allergens, drugs and poisons, heavy metal salts, radionuclides [11].

A linear dependence of the sorption of nisin and natamycin by an inorganic sorbent with colloidal silicon dioxide has been experimentally established. The sorption efficiency was low, and in the dosage range of 0.5-2.0 g / dm3, it was 19-42 %, respectively (Fig. 2).

Bentonite is a natural montmorillonite with a high specific effective surface on which it interacts with substrates. Due to this fact, bentonite adsorbs proteins, polypeptides, amino acids, enzymes, yeast and bacterial cells [12,13,14, Ошибка! Источник ссылки не найден.].

The experimental results showed (Fig. 3) that bentonite has a high sorption capacity relative to nisin and natamycin. At a dosage of bentonite of 0.5 g / dm3, more than 50% of the total concentration of antibiotics was removed. With an increase in the dose of bentonite to 2.0 g / dm3, the removal efficiency was 80% for nisin and 75% for natamycin.

It is known that bentonite clays are traditionally used in winemaking practice to clarify and stabilize wine. Suspensions of bentonites contain at least 80% of the colloidal fraction, including amorphous silica, which leads to high adsorption properties. This allows not only to qualitatively clarify wine materials, but also to remove labile forms of high-molecular compounds into the sediment, to reduce the concentration of toxic compounds (including pesticides, toxins and even heavy metals).

In our opinion, the high sorption capacity of bentonite for the studied antibiotics of a microbial nature is explained by physical adsorption caused by the forces of intermolecular electrostatic interaction between the negatively charged surface of bentonite and the positive charge of nisin and natamycin.

Based on the results of the research, mathematical models for the decontamination of antibiotics from wines using sorbents of various natures are presented in the form of equations (table).

It follows from the table that with an increase in the value of x (mass concentration of the sorbent), the sorption efficiency, expressed by the value of y, also increases.

thumbnail Fig. 1

Efficiency of sorption of antibiotics from wine depending on the mass concentration of activated carbon, %

thumbnail Fig. 2

Efficiency of sorption of antibiotics from the wine depending on the mass concentration of silicon dioxide, %

thumbnail Fig. 3

Efficiency of sorption of antibiotics from the wine depending on the mass concentration of bentonite, %

Table

Mathematical models (equations of dependence) for decontamination of antibiotics, where y - the sorption coefficient, x - the mass concentration of the sorbent, R2 - the coefficient of determination

4 Conclusion

Theoretical approaches to the disclosure of the mechanisms of transformation and decontamination of antibiotics in wines have been substantiated and formulated.

Possible mechanisms of the sorption action of sorbents of different nature with respect to antibiotics of microbial origin (natamycin and nisin) are disclosed. The proposed interpretation of the mechanism of sorption of nisin and natamycin from wines is that their interaction is based on surface phenomena and is of a physical nature.

A hypothesis has been developed that the high sorption capacity of mineral sorbents for antibiotics of microbial origin is explained by the mechanisms of physical adsorption caused by the forces of intermolecular electrostatic interaction by the negatively charged surface of bentonite and the positive charge of nisin and natamycin, and not due to the adhesion forces that increase with decreasing particle size of the sorbent.

It is shown that the sorption capacity of sorbents for antibiotics decreases in the series: activated carbon, bentonite, and colloidal silicon dioxide.

As a result of the studies carried out on the removal of nisin and natamycin from wines by sorbents of various natures, mathematical models of antibiotic decontamination (in the form of linear equations) are presented.

Acknowledgments.

The study was carried out with the financial support of the RFBR and the AKR in the framework of the scientific project No. 19-416-230067 p_a and partially in the framework of the fulfillment of the State task of the FSBSI NCFSCHVW

References

All Tables

Table

Mathematical models (equations of dependence) for decontamination of antibiotics, where y - the sorption coefficient, x - the mass concentration of the sorbent, R2 - the coefficient of determination

All Figures

thumbnail Fig. 1

Efficiency of sorption of antibiotics from wine depending on the mass concentration of activated carbon, %

In the text
thumbnail Fig. 2

Efficiency of sorption of antibiotics from the wine depending on the mass concentration of silicon dioxide, %

In the text
thumbnail Fig. 3

Efficiency of sorption of antibiotics from the wine depending on the mass concentration of bentonite, %

In the text

Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.

Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.

Initial download of the metrics may take a while.