Issue |
BIO Web Conf.
Volume 89, 2024
The 4th Sustainability and Resilience of Coastal Management (SRCM 2023)
|
|
---|---|---|
Article Number | 01007 | |
Number of page(s) | 14 | |
Section | Environmental Monitoring and Sustainability | |
DOI | https://doi.org/10.1051/bioconf/20248901007 | |
Published online | 23 January 2024 |
Optimization of Land Area Mapping and Volume Calculations using Drone Lidar Livox Mid-40 Data with the Downsampling Method
1,2 Department of Civil Engineering, Institut Teknologi Sepuluh Nopember, Surabaya, Indonesia
3 Department of Geomatics Engineering, Institut Teknologi Sepuluh Nopember, Surabaya, Indonesia
4 Department of Informatics Engineering, Institut Teknologi Sepuluh Nopember Surabaya, Indonesia
5 Department of Mechanical and Materials Engineering, Uniersiti Kebangsaan Malaysia, Selangor, Malaysia
6 College of Agriculture and Forestry, West Visayas State University, Philippines
One reason for the growing acceptance of 3D point cloud-based research and applications is the quick advancement of 3D scanning technologies. However, there are still a number of serious issues that have an impact on point cloud utilization performance. Among these difficulties are controlling the quantity of points, irregular point density, and a deficiency of location proximity data. In this study, we use Livox Mid-40 Drone Lidar Data and a downsampling technique to compute land area and volume. However, it can be highly challenging and time-consuming to extract usable information from enormous amounts of gathered data. Motivated by these results, this study recommends using downsampling approaches to minimize the size of the final data set while preserving data integrity, which will facilitate and expedite. The Livox Mid-40 Lidar Drone data was optimal at 00:00:30 with a flying height of 75,719 meters and a measurement diameter of 50.3 meters. By using downsampling techniques, the number of points can be reduced by up to 40 percent from the previous number of data points. Meanwhile, the data size can be 10 percent smaller than the original data. To calculate the area of land of the same size, there is a difference of 0.53 square meters. Meanwhile, for the calculation of cubic volume, there is a difference of 1.63 cubic meters.
Key words: Optimization / Land Area Mapping / Volume Calculations / Drone Lidar Livox Mid-40 Data / Downsampling Method
© The Authors, published by EDP Sciences, 2024
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.